Hardware not obeying duration setting.

upload scenes in the standalone memory of the interface
Post Reply
audiopyle
Posts: 13
Joined: 26 September 2014, 02:09

Hardware not obeying duration setting.

Post by audiopyle »

I have a few scenes that run properly in the software on 3DView, but when uploaded to the Xpress-512Plus they do not obey the "duration" setting. The lights are supposed to travel to a certain position and stop, but they seem to rock continuously at the end step. I have already emailed you the show file.
Top
Earl Harvey
Posts: 224
Joined: 18 June 2012, 12:09

Re: Hardware not obeying duration setting.

Post by Earl Harvey »

Does your Pan and Tilt amplitude in the profile match the fixture's?
Top
Post Reply

Return to “StandAlone”