Page 1 of 1
the 'room' view is too bright, even on its darkest setting
Posted: 24 January 2013, 10:18
by Lucas_Story
I'm new here so forgive me if i'm posting this in the wrong section but i think the current brightness settings in 3D view aren't very good, the lowest brightness is still quite bright. I would personally love to see better brightness settings in a future update.
Re: Dark 3D
Posted: 24 January 2013, 14:26
by support
Noted.
Re: Dark 3D
Posted: 07 February 2013, 20:52
by dkumpula
Hi Support,
I agree with the request and would add that while you are adjusting this to please ensure that the brightness of the devices scale linearly with dim. Frequently I find my devices that look appropriate when the device is at full brightness, but they can't be seen in 3D at all when set to 1/3 of full power.
Thanks as always!
-David
Re: Dark 3D
Posted: 31 October 2013, 16:24
by Clive
Hi Support,
I have been visualising in 3DView, great application, but I too agree that the 'room' view is too bright even on its darkest setting. Is there any news on this since the start of this thread; or perhaps a workaround - a registry setting that can be tweaked or something?
Many thanks.
Re: Dark 3D
Posted: 01 November 2013, 10:52
by support
Noted in ToDo list.
Re: the 'room' view is too bright, even on its darkest setting
Posted: 03 November 2013, 17:39
by zkflow
For me the solution was change the values for color in all the fixture to get the darkest setting posible... but that's very annoying...
Re: the 'room' view is too bright, even on its darkest setting
Posted: 03 November 2013, 20:18
by Lighter007
zkflow wrote:For me the solution was change the values for color in all the fixture to get the darkest setting posible... but that's very annoying...
I did the same, but, as zkflow just said, it is annoying.
