I've created a new show using fixtures used in previous shows without issues. The difference now is that instead of scanners being assigned the same dmx channels (clones) I'm addressing each one individually.
Fixtures 1-3 are fine but fixture 4 does not respond to tilt values. I've not tried the dmx output yet but 3d view certainly does not give me a visualisation.
All fixture were created and adressed at the same time in setup and all settings are identical.
What am I doing wrong please?
one fixture is not responding [fixed]
Re: 3d view issues
Sorted it!!
I had a conflict with a patched dmx output which was overiding the the new editor values.
I had a conflict with a patched dmx output which was overiding the the new editor values.