J-Maz - FX 5050 bar

[Ssawahl]

I have a few J-MAZ Pixel FX 5050 bars I would like to try to creat pixel effects with but the fixture profile does not appear in the Pixels folder. Does a profile for these exist?

Thank you

[support]

Please provide a link to download the manual of this DMX fixture and we will do the profile for you.
FYI: https://forum.thelightingcontroller.com ... f=3&t=2453

Alternatively, you can also do the profile by yourself in the module "Pixels".

[Ssawahl]

https://www.americanmusical.com/media/m ... maUcxAR0er

And I'm using the the bar as 18 channels

Thank you

[support]

The 18 channels mode is not suitable for our module "Pixels" because it does not have individual pixel control.
And our software can manage RGB, RGBW or W (white) pixels, but it is more sensible with several white pixels followed by several RGB pixels.

So we propose to use the mode 61 channels and to make two fixtures:
- one with channel #3 to #12 for the white pixels
- one with channels #33 to #56 for the RGB pixels

Please let us know.

[Ssawahl]

Oh ok thank you. Sadly I will not be able to add them that way they would take up too many spots in my setup.

Thank you.

[Ssawahl]

Good afternoon I finally was able to upgrade to the Xpress 1024w so now I can set up the 5050 bars in 61 channel mode but when adding the fixture to pixels the shared channels only go up to 30 the RGB LEDs are channels 33 through 56 as you mentioned in an earlier reply. How do I create this?