Calibrate moving heads in generator [fixed]

[Pauluzzz]

One of my moving heads fell on the floor and luckily it did not break apart, the only damage is that the head now starts a few degrees to the left when it switches on in comparison to its brothers. Before opening it up and attempt to repair it (likely destroy it forever), is there a way that I can offset the head so that it is in sync again? Like adding automatically a couple points extra into the X channel for this fixture when building a curve so it gets an extra push? Thanks.

[support]

This is possible in V9.
https://www.youtube.com/watch?v=UY49FS6 ... R7NHx&t=0s