Page 1 of 1
ControlBoard error message "licence not found" [fixed]
Posted: 17 January 2010, 01:44
by delivermemedia
everytime i go to run control board it gives me a message failure license not found any ideas on what I'm doing wrong??
Re: ControlBoard error message "licence not found"
Posted: 17 January 2010, 17:37
by support
This means some files were not copied from the DMG file to the software folder.
Please try a new software install.
If the problem still exists, may be your procedure to install the software is different than ours (?)
In that case, please tel us what is your installation procedure.
Re: ControlBoard error message "licence not found"
Posted: 21 January 2010, 01:14
by delivermemedia
I dont have an installation procedure how are you installing it??
Re: ControlBoard error message "licence not found"
Posted: 21 January 2010, 08:30
by support
Like any other MacOS software.
Just copy the DMG contents into your computer.
Re: ControlBoard error message "licence not found"
Posted: 22 January 2010, 15:01
by support
Ok, we just updated the DMG files.
All the files are now into another folder.
So now, you just have to slide this folder in your "Application" folder.