Page 1 of 1
Q-Blender X-Y Function [Available?]
Posted: 18 December 2024, 16:04
by zhincic
Is there a way to make a scene in steps or even generator editor - and later - inside 'LIVE' - to have a fader that gives you an ability to expand or decrease the X & Y values - so it expands or reduces the moving radius, depending on your raising or lowering of the fader.
I've seen this possible with ONYX software by Obsidian Control.
Thank you, in forward!

Re: Q-Blender X-Y Function [Available?]
Posted: 18 December 2024, 17:04
by support
No this is not possible in "Live" (real time) because our Generator concept is different.
In generator, we draw the entire pan/tilt movement, so expand/decrease this movement raise some questions without logical answer like based from what point.
FYI, with our software V_II, it is possible to add one Generator movement to another one. This is not what you are asking for, but we just inform you because this is a nice feature.
Re: Q-Blender X-Y Function [Available?]
Posted: 18 December 2024, 21:06
by zhincic
But, with steps - is it possible inside Live?
Re: Q-Blender X-Y Function [Available?]
Posted: 18 December 2024, 22:40
by support
No it is not, for similar reasons.