The Lighting Controller

Dear friends,

I would like to use de the x&y generator from an initial position (only X and Y parameters). For example, all the beams installed around the dancefloor aiming to center of the floor, and from that point, start the X&Y generator. How can achive that?

Thank you for your help.

Hello,

The software (V9) does not allow to add a Generator scene over another scene.
Sorry for that.

Please note this is possible with our new software (V_II): https://www.youtube.com/watch?v=paIRRUA ... 4AdKM5naDx

Thank you for your answer.

Is possible to export a project from QuickDmx with a quickdmx 1024 rack for V_II software?

Thanks again

No this is not possible.
We explain the reasons here: https://forum2.thelightingcontroller.co ... c.php?t=20

Note: all V9 fixtures profiles have been converted and added in V_II.