No Output from ShowExpress 1024
Posted: 06 November 2023, 02:02
I built a timeline for a halloween show. However, when I went to use it, it would not output the DMX no matter what I tried.
Version 9.2.38, ShowExpress 1024, MacOS, 18 fixtures 4 channels each, 4 channels apart, , DMX turned on, 3dViewer showing simulation, video playing. (Also, the 3dViewer isn't centered, most of the window black and my stage is in the bottom corner )
No matter what I try it will not output to the fixtures. I did try a single fixture on a new project just turning on and off, that worked. So I assume the interface is good.
Is there something I am missing?
Version 9.2.38, ShowExpress 1024, MacOS, 18 fixtures 4 channels each, 4 channels apart, , DMX turned on, 3dViewer showing simulation, video playing. (Also, the 3dViewer isn't centered, most of the window black and my stage is in the bottom corner )
No matter what I try it will not output to the fixtures. I did try a single fixture on a new project just turning on and off, that worked. So I assume the interface is good.
Is there something I am missing?