The Lighting Controller

Posted: **23 February 2015, 22:02**

I noticed in version 7.1.12 that when choosing a range of channels including channels that are not being used and then selecting "Set Value of Selected Channels on All Steps" results in those empty channels being set to a value of 2 or 0. This was an old error. This should not result in an unused channel being set to any value. It should continue to be blank. This was a problem years ago, but has been corrected for at least the last 5 years.

Thank you for your help.

-David

Posted: **24 February 2015, 11:41**

You're right, it will be corrected for the next release.

Posted: **24 February 2015, 14:37**

Great! Thank you for your help!

The Lighting Controller

Set Value of All Steps on Empty Channels Set Incorrectly

Set Value of All Steps on Empty Channels Set Incorrectly

Re: Set Value of All Steps on Empty Channels Set Incorrectly

Re: Set Value of All Steps on Empty Channels Set Incorrectly