The Lighting Controller

Hi all. I am just now starting to set up LIVE buttons for use. Is there a way to have a certain group of buttons be mutually exclusive. By that I mean, for example:

I have buttons for brightness of a particular fixture that say DIM, MEDIUM, and BRIGHT. I would not want more than one of these buttons to be pressed and active at any one time.

Is there a way that I can set up those three buttons so that if I press BRIGHT and DIM was previously enabled, the DIM button will disable, and so on?

Thanks,
Rob

Yes assign then to an exclusive page and make the page solo buttons... this will allow you to only select one button at a time...