Page 1 of 1
Movinghead slow in playback
Posted: 05 June 2013, 21:13
by MickeyMick
Movinghead is slow in playback but not slow when ik manually click the steps.
I want to create a scene with the heads shooting a beam and then move (blackout) to another position and then shoot again
My head is a showtec led 50.
Re: Movinghead slow in playback
Posted: 06 June 2013, 08:40
by support
For the fastest movement, the transition mode (button below the vertical fader) must be set to "snap" mode.
For "blackout move", you can set channel 12 to "blackout during Pan/Tilt movement" (dmx level 18).
Re: Movinghead slow in playback
Posted: 07 June 2013, 07:02
by MickeyMick
Is there a trick to setup up the head (in positon) before the shutter opens?
I know you can do it with programming but is there something so the head knows where his posiotin is gotta be?
i want to shoot beams one by one.
head 1
head 2
head 1
head 2
etc.
Re: Movinghead slow in playback
Posted: 07 June 2013, 07:07
by MickeyMick
Are there coming new curves for the generator in the future?
Re: Movinghead slow in playback
Posted: 07 June 2013, 10:56
by MickeyMick
Tried it today, but still slow!.
Re: Movinghead slow in playback
Posted: 07 June 2013, 12:50
by support
In the software, we just propose a few samples of curves.
However, it is open. You can create/open/save any curve you want, in any lightshow.
Re: Movinghead slow in playback
Posted: 07 June 2013, 14:03
by MickeyMick
support wrote:In the software, we just propose a few samples of curves.
However, it is open. You can create/open/save any curve you want, in any lightshow.
Good answer, but not the answer i wanted to hear.
Are you guys making new curves or a share your curve topic
Another problem. When i put my heads in 180 degree mode. I cant use the generator, i have to turn my heads 90 degrees. Is there a solution for this?