Page 1 of 1
ETC - Source 4/Fresnel
Posted: 15 October 2012, 22:04
by colep
Re: ETC - Source 4/Fresnel
Posted: 16 October 2012, 06:47
by support
Done.
Please note that you can easily adjust the "color" (to make "warm light" rendering) in Setup > section "3DView" > button "beam color".
Re: ETC - Source 4/Fresnel
Posted: 17 October 2012, 23:20
by colep
Ok thank you. I do not see the beam color in the setup 3D view. All there is is what it will show up as on 3D view, type of bulb, pan, tilt, beam angle, reverse dimmer, reverse iris, and what it will show up as in the 2D view. Am I in the wrong spot? Thanks!
Re: ETC - Source 4/Fresnel
Posted: 17 October 2012, 23:21
by colep
Nevermind, I just found it as I posted that. Thanks again!