D512 and iMove 50SR Moving Head DMX Problems
Posted: 21 October 2011, 18:56
Hi Guys,
My D512 interface arrived today, I set it up and just connected the moving heads to test out... I got support to create me the profile and all looked well, however, when I plug in and just try and move the faders in the editor some things work, some faders are wrong e.g. shutter actually controls x/y speed. All the faders seem wrong, I havent been able to find a fader which opens the shutter yet.
I have checked the programming and all seems fine, I am running the 16 channel setup. Any ideas? Note - the D512 firmware is 1.04 - would this have an effect, also, I have removed all other lights and reset the dmx addresses. head 1 is on DMX 001 and head 2 is on DMX 017
Cheers John.....
My D512 interface arrived today, I set it up and just connected the moving heads to test out... I got support to create me the profile and all looked well, however, when I plug in and just try and move the faders in the editor some things work, some faders are wrong e.g. shutter actually controls x/y speed. All the faders seem wrong, I havent been able to find a fader which opens the shutter yet.
I have checked the programming and all seems fine, I am running the 16 channel setup. Any ideas? Note - the D512 firmware is 1.04 - would this have an effect, also, I have removed all other lights and reset the dmx addresses. head 1 is on DMX 001 and head 2 is on DMX 017
Cheers John.....