Hi I've just dusted off the unit after not using it for a few years. Downloaded the latest software for pc.
The effect I'm creating using the generator is for a flame effect using 3x generic rgb fixtures. I'm using the generator to make a 6 pulse red and green for orange with added blue flicks. Running on pc is fine with the remote connected via usb to the lights, however when I add the generator to a standalone channel and run the controller without pc it can only be described as as going from a smooth 16 bit operation to a 8 bit. The lights fade more and isn't as smooth. Do you have any suggestions? I suspect the unit is minimum 4 years old so may need a firmware flash for newer software?
Thanks, Chris