Connecting to Capture visualizer via ArtNet [done]

control Artnet fixtures

Connecting to Capture visualizer via ArtNet [done]

Postby Bruce » 15 December 2019, 13:56

I've been using the 3D viewer in ShowXpress for some time, and now I'd like to experiment with using Capture as a third-party visualizer. Since Capture supports Art-Net, I'm hoping that's possible. The Capture documentation suggests that the Capture software can run on the same computer, and respond to Art-Net messages from lighting controller software running on the same hardware. Sadly, thus far I've been unable to make it work with ShowXpress.

In theory, is it possible to connect third-party visualizer software to ShowXpress?
Bruce
 
Posts: 2
Joined: 25 November 2018, 08:21

Re: Connecting to Capture visualizer via ArtNet

Postby support » 15 December 2019, 17:19

Depending of your connected dmx interface, our software can output the Artnet universes via the Ethernet port of the computer.
But we do not know if this is possible to internaly link this Ethernet port to another software inside the computer.
The Lighting Controller
support
Administrateur
 
Posts: 8676
Joined: 07 December 2009, 16:32

Re: Connecting to Capture visualizer via ArtNet

Postby Bruce » 16 December 2019, 07:30

Thanks for your reply, Support.

Today I set up the Capture visualizer on a second computer, hoping that would solve the problem. No.
I then played around with DMX-Workshop to see if it could detect Art-Net signals being sent from ShowXpress. Nothing.
At my wit's end, I stumbled across this statement:

"To enable Artnet control with our software, the software has to find one of these interfaces: dmx interfaces.
Then the Artnet signal is sent via the Ethernet port of the computer."


Oh! You mean I have to have the ShowExpress hardware plugged in? My whole purpose in connecting the Capture visualizer is to see my light show when I don't have access to the ShowExpress hardware (it's at my place of work).

Please excuse me while I go outside and headbutt a tree.
Bruce
 
Posts: 2
Joined: 25 November 2018, 08:21

Re: Connecting to Capture visualizer via ArtNet

Postby support » 16 December 2019, 08:13

Yes, Artnet needs the dmx interface.
Thank you for your feedback.
The Lighting Controller
support
Administrateur
 
Posts: 8676
Joined: 07 December 2009, 16:32


Return to Artnet

Who is online

Users browsing this forum: No registered users and 1 guest

cron