Minor Error in Setup - Insert Level

declare your lighting equipment

Minor Error in Setup - Insert Level

Postby dkumpula » 01 August 2012, 20:07

Hi folks,

I just noticed a minor error I noticed in the editor. When a level is changed to start at something higher than zero (e.g. 0 changed to 1), the "insert level" button is not immediately enabled. If you save the device and go back into it, it does display the "insert level" properly. (Note: Changing the top value of a level from 255 to something lower does correctly enable the "add level" button.)



This is a very minor issue, to be sure.

-David
dkumpula
 
Posts: 66
Joined: 28 June 2010, 23:08
Location: Fort Mill, SC - USA

Re: Minor Error in Setup - Insert Level

Postby support » 02 August 2012, 08:28

Thank you for the info.
Noted.
The Lighting Controller
support
Administrateur
 
Posts: 10538
Joined: 07 December 2009, 16:32


Return to Setup

Who is online

Users browsing this forum: No registered users and 1 guest