The fixture is linked to the interface via a dmx cable, and it is powered.
The fixture says that it is receiving a dmx signal, but it does not respond to the faders.
Please check that the dmx output is "on".
The Lighting Controller
technical forum - dmx software & interfaces for Windows & Mac computers
The fixture does not respond to the faders
1 post
• Page 1 of 1
The fixture does not respond to the faders
by support » 27 May 2015, 08:24
The interface is found by the software, and its LED is blinking.
The fixture is linked to the interface via a dmx cable, and it is powered.
The fixture says that it is receiving a dmx signal, but it does not respond to the faders.
Please check that the dmx output is "on".
The fixture is linked to the interface via a dmx cable, and it is powered.
The fixture says that it is receiving a dmx signal, but it does not respond to the faders.
Please check that the dmx output is "on".
The Lighting Controller
- support
- Administrateur
- Posts: 9059
- Joined: 07 December 2009, 16:32
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests