I noticed in version 7.1.12 that when choosing a range of channels including channels that are not being used and then selecting "Set Value of Selected Channels on All Steps" results in those empty channels being set to a value of 2 or 0. This was an old error. This should not result in an unused channel being set to any value. It should continue to be blank. This was a problem years ago, but has been corrected for at least the last 5 years.
Thank you for your help.
-David
The Lighting Controller
technical forum - dmx software & interfaces for Windows & Mac computers
Set Value of All Steps on Empty Channels Set Incorrectly
3 posts
• Page 1 of 1
Set Value of All Steps on Empty Channels Set Incorrectly
by dkumpula » 23 February 2015, 22:02
- dkumpula
- Posts: 66
- Joined: 28 June 2010, 23:08
- Location: Fort Mill, SC - USA
Re: Set Value of All Steps on Empty Channels Set Incorrectly
by Niffo » 24 February 2015, 11:41
You're right, it will be corrected for the next release.
- Niffo
- Administrateur
- Posts: 717
- Joined: 07 December 2009, 15:59
- Location: France
Re: Set Value of All Steps on Empty Channels Set Incorrectly
by dkumpula » 24 February 2015, 14:37
Great! Thank you for your help!
- dkumpula
- Posts: 66
- Joined: 28 June 2010, 23:08
- Location: Fort Mill, SC - USA
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests