Epsilon - DuoBeam Bar
Posted: 22 December 2018, 04:27
I am not sure if these can be portrayed accurately or at all in the 3D view. I tried the multiple head option and it shows up that way when choosing fixtures in the 3D view, but what I see in the 3D view makes no sense.
It shows multiple heads tied together across the stage. (Ex. 1 fixture far stage right, the next 2 spread out evenly about 15% towards stage left, and the next far stage left. Being tied together I can move them collectively maybe half way across the screen. There is no independent control over any of them, they all turn on and off at once).
I purchased another Xpress 512 box just for these lights because they use 16 channels each, (I passed the 512 channel quota). I am hoping there is more control than I am getting over these things. See what you can do with them.
The following link is to my Google Drive, it should take you directly to the manual. If not, I also uploaded it as a .zip file via the "upload attachment" tab.
https://drive.google.com/open?id=1DqVxw ... ilKDbCVOE0
I tried to upload the manual but no matter what I do it says the file is too big. I hope the link to my Google drive works for you even though it is out of the scope of your posted instructions. If not, please advise.
Thank you very much.
Ted Nelson
It shows multiple heads tied together across the stage. (Ex. 1 fixture far stage right, the next 2 spread out evenly about 15% towards stage left, and the next far stage left. Being tied together I can move them collectively maybe half way across the screen. There is no independent control over any of them, they all turn on and off at once).
I purchased another Xpress 512 box just for these lights because they use 16 channels each, (I passed the 512 channel quota). I am hoping there is more control than I am getting over these things. See what you can do with them.
The following link is to my Google Drive, it should take you directly to the manual. If not, I also uploaded it as a .zip file via the "upload attachment" tab.
https://drive.google.com/open?id=1DqVxw ... ilKDbCVOE0
I tried to upload the manual but no matter what I do it says the file is too big. I hope the link to my Google drive works for you even though it is out of the scope of your posted instructions. If not, please advise.
Thank you very much.
Ted Nelson