Ooops...forgot the attach. earlier....here it is..
Using V6.25, I would like to create a test scene where Red, Green, and Blue (R,G,B) step thru 10 seconds each in DMX mode.
According to the COLORSTRIP manual, DMX channels 210(RGB Mode?), 211(R), 212(G), and 213(B) must be used.
When I "RUN" the program in the Editor, the Strip does light up, but colors change in some strange ways! I have attached screen shots of my software setup. The COLORSTRIP hardware was setup as per the manual (The control panel on the back of the COLORSTRIP displays 210). Specific questions I have are:
1. What are the functions and channel levels for DMX Ch. 210 (RGB)? Have I selected the correct function / level? (see attach).
2. In the Editor screen, why does it show CH# as 1,2,3,4 and not 210,211,212, and 213?
3. If I remove STEP 1 (RGB 10 sec), than the COLORSTRIP does not light-up at all while the scene is running. If I include this step in Run, than the COLORSTRIP does get activated while going thru different steps of the scene;just that those colors seem random (often, combinations of two or more colors) in each step
4. On the back of the COLORSTRIP , the control panel reads 210, and I have "saved" this DMX address as per the instructions in the manual. There is a Blue LED on the back of the COLORSTRIP which is continuously blinking, but is is not documented in the Manual. What is this Blue LED about?
Thank you for your help!
Kirit Patel