The Lighting Controller

Thanks! I look forward to trying this one out and I hope I can figure this out. I have been playing with the 48CH PIX version but I still wanted to be able to use the strobe and dimmer functions on the editor page. It is too bad they also did not allow for running the pre-programmed scenes as well for in the editor. Since each pixel is assigned R-G-B, is there a fast way to grab them all at once in editor to make global changes to all. So far in Pixels I have been able to map them just fine but in editor, it will take some time to set each LED to a value. In other words if I want to just take the entire stick to red in editor, I have to go to each pixel and then slide up the red. Any shortcuts that anyone knows of?

It's super easy! Just group the channels together by clicking the proper icon. [see pic]

Thanks Alan. I am looking forward to putting this all together tonight.