by Spaceman273 » 15 September 2016, 04:37
Thanks! I look forward to trying this one out and I hope I can figure this out. I have been playing with the 48CH PIX version but I still wanted to be able to use the strobe and dimmer functions on the editor page. It is too bad they also did not allow for running the pre-programmed scenes as well for in the editor. Since each pixel is assigned R-G-B, is there a fast way to grab them all at once in editor to make global changes to all. So far in Pixels I have been able to map them just fine but in editor, it will take some time to set each LED to a value. In other words if I want to just take the entire stick to red in editor, I have to go to each pixel and then slide up the red. Any shortcuts that anyone knows of?