Here´s a little check list:
At the fixture:
- Be sure DMX Mode is activated and DIP switches are setted up correctly (Starting adress1 is okay for testing).
- Take a look in the manual (if there´s one
)
- At the most fixtures there´s an LED which blinks when it receives DMX signal
At the Soft-/Hardware:
- Which Interface do you have?
- Look if the "PC-LINK" Led is on.
and now:
Go directly into editor ->steps and turn on the DMX (little symbol, top right corner)
Play a little bit with the first six channels. As far as I know there should still be a DMX output although no fixture is setted up.
If there´s a dimmer channels also turn it up.
Don´t make it too complicated with Timeline etc
What happens now?
Regards,
Lighter007