Page 1 of 1

cable drivers installed but not being reconised

PostPosted: 18 June 2011, 11:23
by djhazzaa
I baught the sweetlight usb to dmx from a shop in my city. it was a demo piece of equipment so it has been inslled on another computer. but from what i have read shouldnt make any difference. But my problem is this. i install the software fine, but the drivers dont seem to install correctly. As when i load up the sweetlight software windows it says that no universe found. i have tried every thing i can think of but still not working. i am running windows vista 32 bit.

Re: usb dmx cable drivers installed but not being reconised

PostPosted: 18 June 2011, 14:06
by support
Please read the manual. It explains how to install the driver manually.

Re: cable drivers installed but not being reconised [fixed]

PostPosted: 20 June 2011, 15:19
by djhazzaa
i tryed to install the drivers manually but still doesnt work.

Re: cable drivers installed but not being reconised

PostPosted: 20 June 2011, 21:35
by support
It was working with the shop computer.
It does not work on your computer.
We just checked the manual driver install, on some of our computers ; it was successful.

May be your computer has a problem ?

Re: cable drivers installed but not being reconised

PostPosted: 21 June 2011, 05:03
by marco
hi ive also had this problem
with me it came from a previuos install of the drivers.
i did remove the installed drivers manualy. run a pc clean programm,then install the latest drivers
did u also tryed plugging it onto another usb port? this also gave me sometimes problems.
grtzz Marco