Page 1 of 1

Driver not digitally signed

PostPosted: 23 March 2012, 23:30
by BLUENINJA9R
Good evening, I am sure this has been asked time and time again, so please accept my apologies for asking it if it has. I have just purchased the Sweetlight DMX cable and downloaded the recent 6.26 version of the software. I run Windows 7 64-bit. When I tried to connect the cable, it couldn't uplaod the driver as it says it is not digitally signed. I have un-installed, re-installed, followed the steps in the manual, and downloaded the latest "digitally signed" drivers linked on the forum but still no luck. Any ideas? Thanks. Ian

Re: Driver not digitally signed

PostPosted: 26 March 2012, 07:19
by support
It looks like, for an unknown reason, you are trying to install old drivers.

Re: Driver not digitally signed

PostPosted: 28 March 2012, 12:28
by BLUENINJA9R
Thanks for replying. The driver I was trying to install was the 1.05b2? I managed a work around using the link DJ Mikey Mike put on the forum, basically putting the laptop into test mode. Thanks
Ian

Re: Driver not digitally signed

PostPosted: 28 March 2012, 12:58
by support
In order to know if the problem is exclusively with your computer, please try to install the software on another computer and check with the interface.