Driver not digitally signed

usb to dmx - 100 dmx channels only for Windows (2011 - 2019)
Post Reply
BLUENINJA9R
Posts: 7
Joined: 23 March 2012, 23:23

Driver not digitally signed

Post by BLUENINJA9R »

Good evening, I am sure this has been asked time and time again, so please accept my apologies for asking it if it has. I have just purchased the Sweetlight DMX cable and downloaded the recent 6.26 version of the software. I run Windows 7 64-bit. When I tried to connect the cable, it couldn't uplaod the driver as it says it is not digitally signed. I have un-installed, re-installed, followed the steps in the manual, and downloaded the latest "digitally signed" drivers linked on the forum but still no luck. Any ideas? Thanks. Ian
support
Administrateur
Posts: 10608
Joined: 07 December 2009, 16:32

Re: Driver not digitally signed

Post by support »

It looks like, for an unknown reason, you are trying to install old drivers.
The Lighting Controller
BLUENINJA9R
Posts: 7
Joined: 23 March 2012, 23:23

Re: Driver not digitally signed

Post by BLUENINJA9R »

Thanks for replying. The driver I was trying to install was the 1.05b2? I managed a work around using the link DJ Mikey Mike put on the forum, basically putting the laptop into test mode. Thanks
Ian
support
Administrateur
Posts: 10608
Joined: 07 December 2009, 16:32

Re: Driver not digitally signed

Post by support »

In order to know if the problem is exclusively with your computer, please try to install the software on another computer and check with the interface.
The Lighting Controller
Post Reply

Return to “Cable”