Version 6.28

usb to dmx - 100 dmx channels only for Windows (2011 - 2019)

Version 6.28

Postby JohnRichards » 26 September 2011, 16:53

I have just finished shows using Version 6.27Beta with no problems, and now after the show upgraded to V6.28 and noticed that when my Xpress100 cable is plugged in I can only see the 1st 10 Dmx channels in the scene editor, even if I only have 3 fixtures with under 100 dmx addresses. The Live module still works, and if I unplug the cable I can modify all scenes with the scene editor, but this makes live editing a problem. Re-installing my previous version has sorted the problem out in the meantime. Any suggestions or tweaks to fix new version?
JohnRichards
 
Posts: 362
Joined: 26 September 2011, 16:42

Re: Version 6.28

Postby support » 26 September 2011, 20:53

The Lighting Controller
support
Administrateur
 
Posts: 10538
Joined: 07 December 2009, 16:32

Re: Version 6.28

Postby JohnRichards » 26 September 2011, 21:11

I am totally aware of the limitations of the Xpress100.
I have been using it for many years now.
My only problem is with the new software (version 6.28).
The problem is not there if I go back to Version 6.27Beta.
JohnRichards
 
Posts: 362
Joined: 26 September 2011, 16:42

Re: Version 6.28

Postby JohnRichards » 28 September 2011, 09:04

Is someone from support going to answer my question ?
JohnRichards
 
Posts: 362
Joined: 26 September 2011, 16:42

Re: Version 6.28

Postby support » 28 September 2011, 12:57

This was a beta version.
The Lighting Controller
support
Administrateur
 
Posts: 10538
Joined: 07 December 2009, 16:32

Re: Version 6.28

Postby JohnRichards » 28 September 2011, 16:56

So is V6.27 as per your website.
Which one is the correct one to use ?
JohnRichards
 
Posts: 362
Joined: 26 September 2011, 16:42

Re: Version 6.28

Postby JohnRichards » 28 September 2011, 17:00

I also needed to say that the version loaded with the problem is Version 6.281, your lastest release on the web which is not a beta version.
JohnRichards
 
Posts: 362
Joined: 26 September 2011, 16:42

Re: Version 6.28

Postby JohnRichards » 29 September 2011, 18:01

Let me try again.
Does support register my fault as a problem ?
JohnRichards
 
Posts: 362
Joined: 26 September 2011, 16:42


Return to Cable

Who is online

Users browsing this forum: No registered users and 7 guests