Standalone - Ver 8.2.18

upload scenes in the standalone memory of the interface

Standalone - Ver 8.2.18

Postby marcchauvin » 17 May 2017, 12:09

I recently updated to version 8.2.18 for a new install of a 512 Plus triggered by remote control for a school. I have used the 512 plus/remote combination in the past with version 6 without issue - creating scenes and loading them from the original control board menu. I see where to load scenes in the new "standalone" page, but when I trigger them they play only for the duration of the scene, where the old version was a static scene of unchanging time unless you built it int steps. How can I get my scenes to either loop or have no end point?
marcchauvin
 
Posts: 2
Joined: 12 January 2010, 21:28

Re: Standalone - Ver 8.2.18

Postby support » 17 May 2017, 21:30

Please read this to check the generated scene: viewtopic.php?f=74&t=5125
The Lighting Controller
support
Administrateur
 
Posts: 6547
Joined: 07 December 2009, 16:32


Return to StandAlone

Who is online

Users browsing this forum: No registered users and 1 guest